RIGOL DP832A - Manual (Page 115)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-91
[:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
Syntax [:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]
{<numericvalue>|DEFault}
[:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate]:STEP[:INCRement]? [{DEFault}]
Description Set the step of the voltage change of the specified channel.
Query the step of the voltage change of the specified channel.
Parameter Name Type Range Default
[<n>] Integer 1|2|3 1
<numeric value> Real
0 to the maximum voltage of
the specified channel
Refer to the
"Explanation"
Explanation  When [:SOURce[<n>]] or [<n>] is omitted, the system sets the
corresponding parameter of the channel currently selected.
 <numeric value> is the step value specified. DEFault denotes the default
value. The default values of <numeric value> are as shown in the table below.
Model Default Value of <numeric value>
DP831A/DP832A/DP821A/DP811A
DP831
[1]
DP832/DP821/DP811 [1]
0.001V
CH1: 0.001V; CH2/CH3: 0.01V
0.01V
Note [1] : When DP831 (DP832, DP821 or DP811) is installed with the high resolution
option, its default step value is the same with that of DP831A (DP832A, DP821A or
DP811A).
 When the parameter in the
[:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate][:AMPLitude] command is set
to UP or DOWN, the voltage will increase or decrease at the step set by this
command when this command is executed.
Return Format The query returns the step of the voltage change of the specified channel, for
example, 0.100V.
Example :VOLT:STEP 0.1 /*Set the step of the voltage change of the current channel to
0.1V*/
:VOLT:STEP? /*Query the step of the voltage change of the current channel
and the query returns 0.100V*/
Related
Command
[:SOURce[<n>]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]