RIGOL DP832A - Manual (Page 54)

RIGOL Chapter 2 Command System
2-30 DP800 Programming Guide
:INITiate Command
The :INITiate command is used to initialize the trigger system of the instrument.
:INITiate
Syntax :INITiate[:IMMediate]
Description Initialize the trigger system.
Explanation  When the trigger type ( :TRIGger[:SEQuence]:SOURce
or :TRIGger:IN:CHTYpe ) is set to "IMM" (immediate trigger), the instrument
will execute a complete trigger operation after executing this command.
 When the trigger type ( :TRIGger[:SEQuence]:SOURce
or :TRIGger:IN:CHTYpe ) is set to "BUS" (Bus trigger, namely software trigger),
executing this command will initialize the trigger system. Then, send the *TRG
command to trigger the power supply and the power supply will starts the
trigger operation after the specified delay time (when the delay time is set
( :TRIGger[:SEQuence]:DELay )).
 You can also send the :TRIGger:IN:IMMEdiate command to initialize the
trigger system.
Related
Commands
:TRIGger[:SEQuence]:SOURce
:TRIGger:IN:CHTYpe
*TRG
:TRIGger[:SEQuence]:DELay
:TRIGger:IN:IMMEdiate