RIGOL DP832A - Manual (Page 38)

RIGOL Chapter 2 Command System
2-14 DP800 Programming Guide
:DELAY:GROUPs
Syntax :DELAY:GROUPs <value>
:DELAY:GROUPs?
Description Set the number of output groups of the delayer.
Query the number of output groups of the delayer.
Parameter Name Type Range Default
<value> Integer 1 to 2048 1
Explanation  The number of output groups refers to the number of times that the
instrument turns on or off the output according to the preset state.
 The total number of groups of the delay output = the number of groups × the
number of cycles. Wherein, the number of cycles is set by the :DELAY:CYCLEs
command.
 The power supply will terminate the delayer function when the total number of
groups of delays is finished or when the state that meets the "stop condition"
(the :DELAY:STOP command) is detected. At this point, the state of the power
supply depends on the setting of the :DELAY:ENDState command.
Return Format The query returns an integer from 1 to 2048.
Example :DELAY:GROUP 125 /*Set the number of groups to 125*/
:DELAY:GROUP? /*Query the current number of groups and the query
returns 125*/
Related
Commands
:DELAY:CYCLEs
:DELAY:STOP
:DELAY:ENDState