RIGOL DP832A - Manual (Page 83)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-59
:OUTPut:OVP:CLEAR
Syntax :OUTPut:OVP:CLEAR [CH1|CH2|CH3]
Description Clear the label of the overvoltage protection occurred on the specified channel.
Parameter Name Type Range Default
[CH1|CH2|CH3] Discrete CH1|CH2|CH3 None
Explanation  Before executing the command, make sure that the reason that causes the
OVP on the specified channel is cleared (you can decrease the output voltage
to be below the OVP value or increase the OVP value to be greater than the
output voltage).
 When [CH1|CH2|CH3] is omitted, the system clears the label of the OVP
occurred on the current channel.
 You can also send the [:SOURce[<n>]]:VOLTage:PROTection:CLEar command
to clear the circuit and label of the OVP occurred on the specified channel and
turn on the corresponding channel output.
 You can send the :OUTPut:OVP:ALAR? or :OUTPut:OVP:QUES? command to
query whether OVP occurred on the specified channel.
Example :OUTP:OVP:QUES? CH1 /*Query whether overvoltage protection currently
occurred on CH1 and the query returns YES*/
(Operation: decrease the output voltage to be below the OVP value or increase the
OVP value to be greater than the output voltage)
:OUTP:OVP:CLEAR CH1 /*Clear the label of the overvoltage protection occurred
on CH1*/
:OUTP:OVP:QUES? CH1 /*Query whether OVP occurred on CH1 and the query
returns NO*/
Related
Commands
:OUTPut:OVP:ALAR?
:OUTPut:OVP:QUES?
[:SOURce[<n>]]:VOLTage:PROTection:CLEar