RIGOL DP832A - Manual (Page 138)

RIGOL Chapter 2 Command System
2-114 DP800 Programming Guide
:SYSTem:COMMunicate:LAN:IPADdress
Syntax :SYSTem:COMMunicate:LAN:IPADdress <ip>
:SYSTem:COMMunicate:LAN:IPADdress?
Description Set the IP address.
Query the current IP address.
Parameter Name Type Range Default
<ip> ASCII string Refer to the "Explanation" None
Explanation  This command is only available when the manual IP configuration mode is
enabled ( :SYSTem:COMMunicate:LAN:MANualip[:STATe] ).
 The format of <ip> is nnn.nnn.nnn.nnn; the first nnn ranges from 1 to 223
(except 127), the other three range from 0 to 255.
 You are recommended to ask your network administrator for an address
available.
 The new setting will only take into effect when
the :SYSTem:COMMunicate:LAN:APPLy command is executed to apply the
network parameter currently set after this command is send.
Return Format The query returns the IP address, for example, 172.16.3.128.
Example :SYST:COMM:LAN:IPAD 172.16.3.128 /*Set the IP address*/
:SYST:COMM:LAN:IPAD? /*Query the current IP address and the
query returns 172.16.3.128*/
Related
Commands
:SYSTem:COMMunicate:LAN:MANualip[:STATe]
:SYSTem:COMMunicate:LAN:APPLy
:SYSTem:COMMunicate:LAN:MAC?
Syntax :SYSTem:COMMunicate:LAN:MAC?
Description Query the MAC address.
Explanation The MAC (Media Access Control) address is also called hardware address and is
used to define the location of the network device. For a power supply, the MAC
address is unique and is usually used to recognize the instrument when assigning IP
address for the instrument. The MAC address (48 bits, namely 6 bytes) is usually
expressed in hexadecimal form, for example, 00-2A-A0-AA-E0-56.
Return Format The query returns the MAC address, for example, 00-2A-A0-AA-E0-56.