RIGOL DP832A - Manual (Page 25)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, function, parameter and using instruction of each DP800 command in
A-Z order.
Main topics of this chapter:
 :ANALyzer Commands
 :APPLy Command
 :DELAY Commands
 :DISPlay Commands
 IEEE488.2 Common Commands
 :INITiate Command
 :INSTrument Commands
 :LIC Command
 :MEASure Commands
 :MEMory Commands
 :MMEMory Commands
 :MONItor Commands
 :OUTPut Commands
 :PRESet Commands
 :RECAll Commands
 :RECorder Commands
 :SOURce Commands
 :STATus Commands
 :STORe Commands
 :SYSTem Commands
 :TIMEr Commands
 :TRIGger Commands
Explanation: In this command system, setting commands relating to the time, voltage, current and power
parameters can be sent with units. Unless otherwise noted, the units available and the default unit of each
parameter are as shown in the table below.
Parameter Type Units Available Default Unit
Time s [1] s
Voltage V, mV V
Current A, mA A
Power W, mW W
Note [1] : For the :TRIGger:OUT:PERIod [D0|D1|D2|D3,]<value> command (setting the period of the square waveform
of trigger output), <value> is a time parameter and the units available are s, ms and us. The default unit is s.