RIGOL DP832A - Manual (Page 163)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-139
:TIMEr:TEMPlet:PERIod
Syntax :TIMEr:TEMPlet:PERIod <value>
:TIMEr:TEMPlet:PERIod?
Description Set the period of Pulse.
Query the period of Pulse.
Parameter Name Type Range Default
<value> Integer 2s to 99999s 10s
Explanation  The actual range of <value> is related to the positive pulse width
( :TIMEr:TEMPlet:WIDTh ) currently set. The actual range available is from
(positive pulse width+1s) to 99999s.
 When Pulse is selected ( :TIMEr:TEMPlet:SELect ), if you want to output more
than two groups of timer parameters, you can increase the number of cycles
( :TIMEr:CYCLEs ) to output the timer parameters created by the Pulse templet
repeatedly.
Return Format The query returns an integer from 2 to 99999, for example, 15.
Example :TIME:TEMP:PERI 15 /*Set the period of Pulse to 15s*/
:TIME:TEMP:PERI? /*Query the period of Pulse and the query returns 15*/
Related
Commands
:TIMEr:TEMPlet:SELect
:TIMEr:TEMPlet:WIDTh
:TIMEr:CYCLEs
:TIMEr:TEMPlet:SELect
:TIMEr:TEMPlet:POINTs
Syntax :TIMEr:TEMPlet:POINTs <value>
:TIMEr:TEMPlet:POINTs?
Description Set the total number of points.
Query the total number of points.
Parameter Name Type Range Default
<value> Integer 10 to 2048 10
Explanation  The total number of points refers to the number of groups of timer parameters
created using the templet currently selected.
 When the total number of points (denoted by P) and the current number of
output groups (denoted by G, :TIMEr:GROUPs ) are different, P groups of
parameters will be created using the templet; then, the number of output
groups will change to P automatically.
 The Pulse templet does not support this parameter.
Return Format The query returns an integer from 10 to 2048, for example, 50.
Example :TIME:TEMP:POINT 50 /*Set the total number of points to 50*/
:TIME:TEMP:POINT? /*Query the total number of points and the query returns
50*/
Related
Command
:TIMEr:GROUPs