RIGOL DP832A - Manual (Page 117)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-93
[:SOURce[<n>]]:VOLTage:PROTection:CLEar
Syntax [:SOURce[<n>]]:VOLTage:PROTection:CLEar
Description Clear the circuit and label of the OVP occurred on the corresponding channel and
turn on the output of the corresponding channel.
Parameter Name Type Range Default
[<n>] Integer 1|2|3 1
Explanation  You can send the [:SOURce[<n>]]:VOLTage:PROTection:TRIPped? command
to query whether OVP occurred on the specified channel.
 Before executing the command, make sure that the reason that causes the
OVP on the specified channel is cleared (you can decrease the output voltage
to be below the OVP value or increase the OVP value to be greater than the
output voltage); otherwise, the command is invalid. Executing this command
will clear the circuit and label of the OVP occurred on the specified channel and
turn on the output of the corresponding channel.
 When [:SOURce[<n>]] or [<n>] is omitted, the system clears the circuit and
label of the OVP occurred on the current channel.
 You can send the :OUTPut:OVP:CLEAR command to only clear the label of the
OVP occurred on the specified channel.
Example :VOLT:PROT:TRIP? /*Query whether OCP occurred on the current channel
and the query returns YES*/
(Operation: decrease the output voltage to be below the OVP value or increase the
OVP value to be greater than the output voltage)
:VOLT:PROT:CLE /*Clear the circuit and label of the OVP occurred on the
current channel*/
:VOLT:PROT:TRIP? /*Query whether OVP occurred on the current channel
and the query returns NO*/
Related
Commands
[:SOURce[<n>]]:VOLTage:PROTection:TRIPped?
:OUTPut:OVP:CLEAR