RIGOL DP832A - Manual (Page 47)

Chapter 2 Command System RIGOL
DP800 Programming Guide 2-23
*ESE
Syntax *ESE <enable value>
*ESE?
Description Enable the bits in the enable register of the standard event register.
Query the bits currently enabled in the enable register of the standard event
register.
Parameter Name Type Range Default
<enable value> Character Refer to the "Explanation" None
Explanation  <enable value> is a decimal value corresponding to the sum of the binary
weights of the bits to be enabled in the enable register of the standard event
register. For the definitions of the bits in the standard event register and their
corresponding decimal values, refer to Table 1-5.
For example, to enable bit2 (query error) and bit4 (execution error) in the
enable register of the standard event register, set <enable value> to 20
(according to 2 2 +2 4 =20).
 After the bits in the enable register of the standard event register are enabled,
the system reports the state of the corresponding bit to the status byte
register.
 When <enable value> is set to 0, executing this command will clear the enable
register of the standard event register.
 You can also send the *PSC (*PSC 1) command to clear the enable register of
the standard event register at the next power-on.
Return Format The query returns a decimal value corresponding to the sum of the binary weights
of the bits to be enabled in the enable register of the standard event register, for
example, 20.
Example *ESE 20 /*Enable bit2 (query error) and bit4 (execution error) in the enable
register of the standard event register*/
*ESE? /*Query the bits currently enabled in the enable register of the standard
event register and the query returns 20*/
Related
Command
*PSC