Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 103)

OMS OMNEO Main Station Configuration | Ports menu | en 103
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
For more information, please refer to Connect OMNEO devices to OMS using Connect
Devices, page 29.
22.2 OMNEO channels
Figure 22.6: Configuration | Ports | OMNEO Channels
Port Field
Use the Port field to select which port to configure.
Device Name Field
Use the Device Name field to enter the name of an OMNEO device to which this port attempts
to connect.
IP Address Field
The IP Address field displays the IP address of the device specified in the Device Name field.
Device Type Field
Use the Device Type field to select the type of device to which this port attempts to connect.
Rx Latency Selection Field
Use the Rx Latency selection field to set the latency threshold of the receive audio. This
setting determines the delay between when a device transmits audio to when that audio is
received on the connected device. It is sometimes necessary to use a higher latency setting in
large networks to avoid brief audio disruptions.
Available options for this field are: 1 ms, 2 ms, 5 ms, 10 ms, 15 ms, and 20 ms.
The default value for this field is 2 ms.
Channel Field
Use the Channel field to select the channel on the partner device to which this port attempts
to connect.
Description Field
The Description field displays the description of the port.
22.3 RVON channels
Figure 22.7: Configuration | Ports | RVON Channels Screen
Port Field
Use the Port
field to select the port alpha for the RVON port.