3 configure the omneo interface, Configure the omneo interface – Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) User Manual
Page 26
26
en | System configuration
OMS OMNEO Main Station
01-2021 | 03 | F.01U.380.820
Technical Manual
Bosch Security Systems, LLC
8.3
Configure the OMNEO interface
To
configure the OMNEO interface from the front panel
, do the following:
1.
Navigate to the
OMNEO icon
.
2.
Click the
ENC2 encoder knob
.
The OMNEO Configuration screen displays.
3.
Enter the
Audio IP address
used to transmit and receive audio across the network.
i
Notice!
The Audio IP address and the Control IP address should be in the same subnet. OMS displays
a warning message if these addresses are not on the same subnet.
4.
Enter the
Control IP address
used by the OMNEO controller to access the network.
5.
Enter the
Netmask address
for the OMNEO interface.
6.
Enter the
Gateway address
for the OMNEO interface, if applicable.
7.
Enter the
DNS Server address
to which the OMNEO has access.
8.
Enter a
recognizable device name
for the OMNEO network connection.
9.
Enter the
domain
for the OMNEO network. By default, the domain is left blank.
10. Select the
Use Static check box
to enable static IP addressing.
i
Notice!
If the Use Static check box is not selected, DHCP/Link-local is used and some of the
remaining fields are automatically populated.
11. Click the
ENC1 encoder knob
to exit.
A confirmation to save or discard changes appears.
12. Rotate the
ENC2 encoder knob
to the
desired action
.
13. Click the ENC2 encoder knob to
confirm
.