Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 24)

24 en | Cables and cable requirements OMS OMNEO Main Station
01-2021 | 03 | F.01U.380.820 Technical Manual Bosch Security Systems, LLC
1 The left LED is orange and indicates a
network link is established. It flashes on/
off whenever there is network activity.
2 The right LED is bi-color (orange and
green) and indicates the speed of the
connection by the color displayed.
–
A green LED indicates the port is
operating at 1000 Mbps (1 Gbps).
This is suitable for OMNEO and RVON
networking.
– An orange LED indicates the port is
operating at 100 Mbps.
– No LED color indicates the port is
operating at 10 Mbps. This is not
suitable for OMNEO nor RVON
networking.
7.4 Network port cabling
Figure 7.1: Rear panel OMS
To cable OMS to a network , do the following:
1. Connect an Ethernet cable to the J10 CONTROL connector.
OR
Connect an
Ethernet cable to the J10 RVON connector.
OR
Connect an
Ethernet cable to the J11 OMNEO A or B (RJ45) connector.
OR
Connect an
SFP fiber connector to the J12 A or B (SFP) connector.
2. Connect the other end of the cable to a network switch.