Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 131)

OMS OMNEO Main Station Configuration | Advanced menu | en 131
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
26.1.4 Debug Shell
Figure 26.6: Configuration | Authentication | Debug Shell
Access Field
Use the Access field to grant access to the debug.
Telnet is available on the Control Port.
Available options are Enabled and Disabled (default).
26.2 GPIO-16 menu
Use the GPIO-16 menu to set the IP addresses of the GPIO-16 devices. OMS uses the Control
Port to communicate to GPIO-16 devices.
Figure 26.7: Configuration | Advanced | GPIO-16 Screen
To configure the GPIO-16 IP address , do the following:
1. Navigate to the desired position .
2. Click the ENC2 encoder knob .
The field becomes active.
3. Set the IP address .
4. Click the ENC2 encoder knob .
5. Click the ENC1 encoder knobto exit the screen .
A Changes Made message appears.
6. Navigate to the desired action .
7. Click the ENC2 encoder knob to confirm .
26.3 Clock Select
Use the Clock Select screen to configure the OMNEO audio PTP clock used to synchronize
audio in an intercom system.
Figure 26.8: Configuration | Advanced | Clock Select
Preferred Master Check Box
The Preferred Master check box determines whether the device is configured as the preferred
master clock for other OMNEO devices on the network.
By default the Preferred Master field is not selected.