Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 82)

82 en | Status | Network menu OMS OMNEO Main Station
01-2021 | 03 | F.01U.380.820 Technical Manual Bosch Security Systems, LLC
Figure 14.3: Status | Network | OMNEO_SFP
Link A Column
The Link A column displays the status for the Link A OMNEO (SFP) fiber connection.
Link B Column
The Link B column displays the status for the Link B OMNEO (SFP) fiber connection.
Link Up Field
The Link Up field displays the status of the fiber link.
Available statuses are:
The fiber module is installed and the link is connected
The fiber module is installed, but the link is not connected
The fiber module is not installed.
Speed Field
The Speed field displays the transmission speed over the OMNEO interface.
The OMNEO interfaces support 100 Mbps and 1 Gbps.
Duplex Field
The Duplex field displays the transmit mode the OMNEO network interface is currently
operating.
Almost all Ethernet interfaces auto-negotiate to full duplex. If the interface displays half duplex
mode, this typically signifies the auto-negotiate failed, resulting in network collisions and
errors.
Available options for this field are:
Half-Duplex Can either transmit or receive, but not both simultaneously
Full-Duplex Can transmit and receive simultaneously
SFP Installed Field
The SFP Installed field displays whether the transceiver module is installed on the device.
This field is directly tied to the Link Up field. If a transceiver module is not installed the
OMNEO (SFP) port cannot be used.
SFP Tx Fault Field
The SFP Tx Fault field displays if a fault has occurred.
Available statuses are:
An error has occurred.