Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 99)

OMS OMNEO Main Station Configuration | Network menu | en 99
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
21 Configuration | Network menu
Use the Network menu to access the settings for the Control port, OMNEO port, and RVON
port.
Figure 21.1: Configuration : Network Menu
21.1 Control port
The Control Port is used to configure the network connection to AZedit.
Figure 21.2: Configuration | Network | Control Port
IP Address Field
The IP Address field is used to enter the IP address assigned to the Control Port interface.
Network Field
The Netmask field is used to enter the netmask address.
Gateway Field
The Gateway field is used to enter the gateway address, if applicable.
DNS Server Field
The DNS Server field is used to enter the DNS server IP address, if applicable.
21.2 OMNEO
Use the OMNEO screen to configure the OMNEO network interface.
Figure 21.3: Configuration | Network | OMNEO
Control IP Field
Use the Control IP field to enter the IP address used by the OMNEO Control interface to
access the network. The Controller sets up audio connections between two OMNEO
configured ports. This address must be in the same subnet as the Audio IP.
By default, OMNEO interfaces use link local range address and are DHCP enabled. If there is a
DHCP server on the network, it takes an IP address from the DHCP server.