Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 29)

OMS OMNEO Main Station Intercom configuration | en 29
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
15. Click the ENC1 encoder knob to exit the screen.
A Changes Made confirmation message displays.
16. Navigate to the desired action .
i
Notice!
Alternately, the ENC1 encoder knob can be clicked or the CLR button can be pressed to
cancel this prompt and go back to editing the underlying screen.
17. Click the ENC2 encoder knob to confirm the selection .
18. Connect the 2-Wire device to the configured XLR connector on the rear panel of OMS.
9.1.2 Connect 4-wire analog devices to OMS
i
Notice!
Applicable for Analog Plus, Intermediate, and Advanced models.
To connect an 4-wire analog device to OMS , do the following:
1. Connect the device to the AIO connector on the rear panel of OMS .
9.1.3 Connect OMNEO devices to OMS using Connect Devices
i
Notice!
Applicable for Analog Plus, Basic, Intermediate, and Advanced models.
To connect OMNEO devices to OMS using the Connect Devices menu , do the following:
1. Navigate to the Configuration icon .
2. Navigate to the Ports icon .
3. Click the ENC2 encoder knob .
The Ports menu displays.
4. Navigate to the Connect Devices icon .
5. Click the ENC2 encoder knob .
OMS scans for available OMNEO devices, and then shows devices that support Easy
Connect (KP-Series, DBP, OKI, etc.). Discoverable devices need to be powered on,
connected to the network, and be on the same subnet.