Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 148)

148 en | Intercom setup | Resources menu OMS OMNEO Main Station
01-2021 | 03 | F.01U.380.820 Technical Manual Bosch Security Systems, LLC
18. Click the ENC2 encoder knob to confirm the selection .
30.4 Relay
Use the Relay screen to configure Relay definitions and options.
Relay definitions must be made for each input port and an output port. The associated relay
activates when the input port and output port crosspoint closes. If there is only an input port
definition or an output port definition, but not both, the definition is incomplete and the relay
does not activate. In addition, UPL statements can activate relays.
Figure 30.5: Intercom Setup | Resources | Relay
Relay Field
Use the Relay field to select the relay to configure.
Scroll Enable Check Box
The Scroll Enable check box determines whether the current relay is visible in the local scroll
list.
Latch Disable Check Box
The Latch Disable check box determines whether the Relay, when assigned to a key, causes
the key to become latch disabled. After making the assignment, clear the latch disable to
override the latch disable for the key.
To
configure a relay , do the following:
1. Navigate to the Relayfield .
2. Click the ENC2 encoder knob .
The field becomes active.
3. Select the desired relay .
4. Click the ENC2 encoder knob to confirm .
5. Navigate to the Scroll Enable check box .
6. Click the ENC2 encoder knob to enable or disable scroll enable .
7. Click the ENC2 encoder knob to confirm .
8. Navigate to the Latch Disable check box .
9. (Optional) Click the ENC2 encoder knob to enable or disable latch disable .
10. Click the ENC2 encoder knob to confirm the selection .
11. Click the ENC1 encoder knob to exit the screen .
A Changes Made message appears.
12. Navigate to the desired action .
13. Click the ENC2 encoder knob to confirm the selection .
30.5 ISO
Use the ISO (Isolate) screen to configure settings for ISOs in the intercom system. ISO is a
means for a keypanel operator to isolate a particular intercom port for private communication.
While the intercom port is isolated, it only hears audio from the keypanel operator. In
television broadcasting, it is typical to ISO a member of the camera party line. The isolated
camera can then receive directions without disruption from other audio traffic on the party
line.