Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 147)

OMS OMNEO Main Station Intercom setup | Resources menu | en 147
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
27. Click the ENC2 encoder knob to confirm the selection .
30.3 Special list
Use the Special List screen to configure Special List membership and options. A special list is
a way for a keypanel operator to talk or listen to several destinations using a single key. This
assignment type is useful for group calls or for paging.
Figure 30.4: Intercom Setup | Resources | Special List
SL Field
Use the SL field to select the special list assignment to configure.
Port Field
Use the Port field to select the port whose SL membership to view or modify.
Member Check Box
The Member check box determines whether the selected port is a member of the special list.
If selected, the port belongs to the special list.
Scroll Enable Check Box
The Scroll Enable check box determines whether the current SL is visible in the local scroll
list.
Latch Disable Check Box
The Latch Disable check box determines whether the SL, when assigned to a key, causes the
key to be latch disabled. Clear the latch disable for the key after the assignment is made to
disable this option.
To
configure an SL , do the following:
1. Navigate to the SL field .
2. Click the ENC2 encoder knob .
The field becomes active.
3. Select the desired SL .
4. Click the ENC2 encoder knob to confirm .
5. Navigate to the Scroll Enable check box .
6. Click the ENC2 encoder knob to enable or disable scroll enable .
7. Navigate to the Port field .
8. Click the ENC2 encoder knob .
The field becomes active.
9. Select the desired port .
10. Click the ENC2 encoder knob to confirm .
11. Navigate to the Latch Disable check box .
12. (Optional) Click the ENC2 encoder knob to enable or disable latch disable .
13. Navigate to the Member check box .
14. Click the ENC2 encoder knob to enable or disable SL Membership .
15. Click the ENC2 encoder knob to confirm the selection .
16. Click the ENC1 encoder knob to exit the screen .
A Changes Made message appears.
17. Navigate to the desired action .