Philips HR7758 - Manual (Page 13)

13 ENGLISH
Fruit filter
With this filter you can make delicious fresh fruit
juices, cocktails or soy milk.The filter prevents pips
and skins from ending up in your drink.
Never overload the filter. Do not put more than
50g of unsoaked dried soy beans or 150g of fruit
in the filter at the same time.
Do not let the appliance run more than 2 times
without interruption. Let the appliance cool down
at room temperature before you continue.
1 Mount the blender jar onto the motor
unit.
C
2 Put the filter in the blender jar.
Make sure that the grooves of the filter fit exactly
onto the ribs inside the blender jar.
3 Close the lid.
4 Pour water or another liquid (milk, juice,
etc.) into the blender jar.
C
5 Put the ingredients in the filter. Do not fill
the filter beyond the top of the sieve
mesh.
Cut fruits into smaller pieces and soak dried
pulses, such as soy beans, before putting them in
the filter.
C
6 Put the stopper in the blender lid.
7 Press the
†
button to switch the
appliance on.
Let the appliance run for approx. 40 seconds.
8 Switch the appliance off and remove the
blender jar from the motor unit.
C
9 Pour the drink out via the pouring lip of
the blender jar.
10 For optimal results, put the jar with the
remaining ingredients back onto the
appliance and let it run for a few more
seconds.
Note: when you are processing a large quantity,
we advise you not to put all the ingredients in the
filter at the same time. Start processing a small
quantity and let the appliance run for a few
seconds.Then switch the appliance off and add
another small quantity, but do not exceed the top
of the sieve mesh. Repeat this procedure until you
have processed all the ingredients. Always keep
the lid on the blender jar during processing.
Tips
C
◗ Pour liquid ingredients into the blender jar
through the hole in the lid.
◗ The longer you let the appliance run, the finer
the blending result will be.
◗ Pre-cut solid ingredients into smaller pieces
before putting them in the blender. If you