Philips HR7758 - Manual (Page 8)

ENGLISH 8
Before first use
◗ Thoroughly clean the parts that will come
into contact with food before you use the
appliance for the first time.
Using the appliance
◗ The appliance can be used with or without
the blender attached to the motor unit. If you
want to use another function than the
blender function, make sure the blender jar
has been removed and the screw cap has
been screwed properly onto the motor
housing.
◗ You can only remove the screw cap to attach
the blender when you have removed the lid of
the food processing bowl, the citrus press or
the meat mincer.
◗ Noise level: Lc= 89 dB [A]
Smart Process Control Panel
This appliance is equipped with a Smart Process
Control Panel to ensure an optimal process and a
perfect end result. Each process button is linked
to a pre-programmed speed profile representing
the optimal process for a specific accessory.
You can increase or decrease the speed up to
3 times by pressing the + or - button.
If you press the pulse button, the appliance will
run at the highest speed. When you release the
button, the appliance will stop or return to the
previously selected processing speed.
You can stop the process at any point by pressing
the stop button.
If you press the same process button again within
40 seconds, the process will continue where it
was stopped.
Built-in safety lock
1 This feature ensures that you can only
switch the appliance on when the
accessories have been placed on the
motor unit in the correct position.When
the accessories have been assembled
correctly, the built-in safety lock will be
deblocked.
C
◗ Bowl
You can only use the bowl and the accessories if
you have assembled the bowl and the lid properly
and when the screw cap has been screwed onto
the motor unit correctly.
If this is the case the dot on the bowl will be
opposite the dot on the motor unit and the dot
on the lid will be opposite the dot on the bowl.
The projection of the lid will complete the shape
of the handgrip of the bowl.
The screw cap has been fastened properly when
the groove on the screw cap is directly opposite
the groove on the motor unit and the two
grooves together form one long groove.
CLICK