Yokogawa GD40 Gas Density Detector - Manual (Page 114)

<6. CALORIE / PARAMETER SETTING>
6-25
IM 11T3E1-01E
X
*CAL.P
(Selection of calibration item)
XX
*CAL.T
(Setting of calibration time)
XX
*STAB.T
(Setting of stabilization time)
XX.XX.XX
*Y_M_D
(Setting of calibration starting time [year/month/day] )
XX.XX
*H_M
(Setting of calibration starting time [hour/minute] )
X
*CYCL.U
(Selection of unit of calibration interval)
XXX
*CYCL.T
(Selection of calibration interval)
[ENT]
*SERVC
[ENT]
[YES]
F0617.ai
*1
*1: See "Figure 6.4 Process at the Setting Level" on page 6-12.
*2: Set a value using the [ ], [ ] and [ENT] keys.
If you enter a value that exceeds the limits, the display shows [*OVER].
Press the [YES] or [NO] key to re-set the value.
*3: The number of digits on LCD varies depending on the unit of the calibration interval (parameter *CYCL.U).
If the parameter is set to "0" (hour), the indication is two-digit number.
If the parameter is set to "1" (day), the indication is three-digit number.
15
*CODE *2
*2
*2
*2
*2
*2
*2
*2
*3
[ENT]
[ENT]
[ENT]
[ENT]
[ENT]
[ENT]
Figure 6.17 Setting of Data for Automatic/Semi-automatic Calibration