Yokogawa GD40 Gas Density Detector - Manual (Page 91)

<6. CALORIE / PARAMETER SETTING>
6-2
IM 11T3E1-01E
6.1 Setting Parameters
Subsections 6.1.1 to 6.1.4 show the setting parameters for each level.
6.1.1 Setting Parameters at Measurement Level
When turned on, the analyzer starts up in the measurement mode (<MEASURE>).
Table 6.1 Setting Parameters at Measurement Level
Mode/Setting parameter Display
Data to be Set
(or Conditions)
Remarks
Measurement mode
Indication of measurement value
Physical density
Compensated density
Calorific value
Indication of message
Unit
Error symbol and number
Alarm mark and number
Indication of HOLD and FAIL
HOLD
FAIL
KG/M3
LB/FT3
KG/M3
LB/FT3
MJ/M3
KBTU
ERR.NO
ALM.NO
HOLD
FAIL
Set the unit in CODE 21.
Set the unit in CODE 21.
Set the unit in CODE 22.
See Figure 6.3 for key operation.
The unit is the one set in the service level.
Appears if an error occurs.
Appears if an alarm occurs.
Appears even during other modes.
Appears during a HOLD state.
Appears if a failure occurs.
DISP mode
Physical density
Compensated density
Calorific value
Sample gas temperature
Sample gas pressure
Analog output 1 (%)
Analog output 2 (%)
DISP
KG/M3
LB/FT3
KG/M3
LB/FT3
MJ/M3
KBTU
ºC
ºF
KPA
MPA
PSI
MA1%
MA2%
Set the unit in CODE 21.
Set the unit in CODE 21.
Set the unit in CODE 22.
Set the unit in CODE 23.
Set the unit in CODE 20.
See Figure 6.3 for key operation.
Selection of parameters to be measured in
the measurement mode.
Read-only
Read-only
Read-only
Read-only