2 parameter setting at operation level, Parameter setting at operation level -7 – Yokogawa GD40 Gas Density Detector User Manual

Page 130

Advertising
background image

<7. HYDROGEN PURITY / PARAMETER SETTING>

7-7

IM 11T3E1-01E

7.2.2

Parameter Setting at Operation Level

To move to the operation level, press the [MODE] key and then enter the password (XXX). Pass-

word is not selected in first condition. When password is necessary, refer to Section 4.2 “Setting

Lists” and selected password what you need.
This level includes the manual calibration mode, which is discussed in Chapter 10.

(1) Operation Level
Select a mode from the following four choices of the operation level. Each press of the [NO] key

cycles through the choices in the order shown below:

1. Measuring range selection mode [S_GAS]

2. Display mode [DISP]

3. Manual calibration mode [MAN.CAL]

Press the [YES] key to enter the desired mode when it is indicated.

XXX

[ENT]

[NO]

[NO]

[YES]

[YES]

[YES]

[YES]

Password is not selected in first condition

[MODE]

Manual calibration mode

Measurement Mode

*PASSW

MAN.CAL

F0702.ai

(See "Figure 7.25 Process of Setting Password" on page 7-29.)

DISP

DISP mode

[YES]

[YES]

[NO]

You can abort the setting operation in any of the modes by pressing [MODE] key.

Doing this will return the analyzer to the measurement mode.

S_GAS

Measuring range selection mode

See the process in Figure 7.1.

See the process in Figure 7.3.

See the process in Figure 10.2.

Figure 7.2 Modes of Operation Level

Advertising
This manual is related to the following products: