Yokogawa GD40 Gas Density Detector - Manual (Page 96)

<6. CALORIE / PARAMETER SETTING>
6-7
IM 11T3E1-01E
6.2 Parameter Setting
[Aborting the Setting Operation]
Press the [MODE] key. Normally, the [MODE] key is used to move from the measurement
(<MEASURE>) mode to a mode at the operation level. It is also used to return to the measure-
ment mode from other modes.
6.2.1 Parameter Setting at Operation Level
To move to the operation level, press the [MODE] key and then enter the password (XXX). Pass-
word is not selected in first condition. When password is necessary, refer to Section 4.2 “Setting
Lists” and selected password what you need.
The operation level offers two mode categories: the measurement and calibration operation
modes.
Note that the function for which you have set a data value at the setting level does not work at
all if that function is turned off at another level. For this reason, care must be taken when dealing
with modes that relate to each other.
This subsection explains the operating procedures for the levels/modes noted below.
The calibration operation mode is discussed in Chapter 9.
(1) Operation level
(2) Density/calorie conversion factor setting mode
(3) Display mode (DISP mode)