FUJITSU CentricStor V3.1D - Manual (Page 186)

186 U41117-J-Z125-7-76
Function bar GXCC
Write Throughput (MB/sec)
Write Overhead (sec)
The PLM uses the Write Throughput and Write Overhead parameters to select the
physical volume which it can release in the shortest time in the event of a reorgani-
zation. Write Throughput specifies the estimated write performance of the write drive in
MB/sec, Write Overhead the estimated overhead in seconds per volume to be
written.The values proposed should be changed only by an expert who is fully aware of
the effects of the settings.
Command buttons along the lower border
OK
Accepts the entry. It becomes effective with “Distribute and Activate”. The “Configu-
ration Changed” symbol (floppy disk symbol) appears in the GXCC main window.
The changed configuration data is stored, even after GXCC has terminated. If the
InfoBroker is restarted or the VLP is shut down without a preceding “Distribute and
Activate”, the data which was changed is lost.
Cancel
Closes the window without accepting the entries. All the entries made since the last time
the window was opened are thus lost.
Reset
All data is reset to the status when the window was opened, even if this concerns list
entries which are currently not selected. All the changes made since the last time the
window was opened are thus lost.
Help
Opens a text window containing help information.