FUJITSU CentricStor V3.1D - Manual (Page 413)

U41117-J-Z125-7-76 413
XTCC RAID systems
In the case of external RAID systems, the information window contains the following infor-
mation:
– vendor ID, product ID
– type and serial number of the RAID system
– firmware release (insofar as this can be queried)
– operating status and any error messages (info)
– internal SINIX name, SCSI topology (CTL) and the connection to the FC fabric
In Fabric Mode, the information “Local Domain x, Port y“ is displayed for the target numbers
128…2047. The local domain is in the value range 1...8. In the case of FC switches with
more than 16 ports, it can differ from the “Domain” displayed in GXCC as follows:
GXCC Domain = 1 2 3 4 5 6 7 8 9 10 11 ... etc.
XTCC Local Domain = 1 2 3 4 5 6 7 8 1 2 3 ... etc.
If multiple RAID systems are contained in CentricStor and it was possible to determine the
firmware version for at least one RAID, the versions of all RAIDs of the same type are
compared. If the versions are different the message “Different Firmware!” is displayed on
the symbols for all RAIDs of this type. This is also done if the version information for a RAID
is missing.
The number contained in the internal SINIX name (e.g. c12t158) is also displayed at the
end point of the connection lines.
In the case of internal RAID systems, the following information is displayed:
– hang condition
– name
– interface type
– target location
In addition, there may be information relating to the physical disks of the RAID system:
– controller
– channel
– SCSI ID
– status
– capacity
The representation of the RAID system is a symbol rather than a photograph of the
product. Its actual appearance may well differ from this.
i