FUJITSU CentricStor V3.1D - Manual (Page 495)

U41117-J-Z125-7-76 495
Explanation of console messages Message lines
SXSB007 <PC> : fcpal<n> (sadm<m>): timeout on target <t> lun <l> CDB <some bytes>
ALERT
For more information, see the section “Timeout on the RAID disk array” on
page 538 and section “Timeout on the MTC drives” on page 539 .
Meaning
An I/O operation has taken too long (minutes!), and as a result has been stopped and
started again.
Response
Notify maintenance staff.
9.2.18 SXSC... (Savecore: organize coredump)
SXSC001 <timestamp> syslog: savecore: dump has been saved in /var/crash
ALERT
Meaning
The previous SINIX session was terminated with a crash. A crash dump was taken which
was automatically saved in the /var/crash directory when the system was rebooted.
Response
Notify maintenance staff.
9.2.19 SXSD... (SCSI Disks: driver shd)
SXSD010 shd<k>t<ctl>: Hostadapter error
ALERT
Meaning
This message indicates a serious error in the communication with the RAID system.
Response
If this message is preceded by the message
xxx: response: error = 0x03, vendor = 0x1d, ....
(the 0x1d is important)
it does not have to be analyzed further. In all other cases, notify maintenance staff.
SXSD013 shd<k>t<ctl>: TIMEOUT @ nnnnnnn
ALERT
See the section “Failover at the RAID system” on page 541
SXSD015 shd<k>t<ctl>: cmd "Write or Read" @ blk <number> key "Not Ready" (0x02) asc
"Drive Not Ready" (0x04) ascq 0x02
WARNING
See the section “Failover at the RAID system” on page 541
i