Festo Контроллеры двигателя SFC-LAC - Manual (Page 136)

5. Commissioning
5−40
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
5.6.3 Description of the I/O data (Record select)
Description of the output data: Record selection
Byte EN Description
1 CCON Control bytes, see section 5.6.5
2 CPOS
3 Record number Pre−selection of record number (0 ... 31)
4 ... 8 ć Reserved (= 0)
Description of the input data: Record selection
Byte EN Description
1 SCON Status bytes, see section 5.6.6
2 SPOS
3 Record number Reply message of record number (0 ... 31)
4 RSB Record status byte
Bit 0 RC1:
1st Record Chaining
For record chaining:
= 0: First chaining condition not configured / not reached
= 1: First further record switching reached
*)
Bit 1 RCC:
Record Chaining Complete
For record chaining (only valid when MC=1):
= 0: Record chaining interrupted. At least one chaining
condition was not reached.
= 1: Record chain was processed to the end of the chain.
5 ... 8 Position, ... Feedback of the position in increments
*) The first chaining condition has been achieved if, after the first record with chaining contidition,
motion complete = 1.