Festo Контроллеры двигателя SFC-LAC - Manual (Page 138)

5. Commissioning
5−42
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
5.6.5 Description of the control bytes CCON, CPOS, CDIR
CCON With control byte 1 (CCON) all the states which must be
available in all operating modes are controlled. The
cooperation of the control bits can be found under the
description of the drive functions in section 5.7.
Control byte 1 (CCON)
Bit EN Description
B0
ENABLE Enable Drive = 1: Drive (controller) enable
= 0: Drive (controller) blocked
B1
STOP Stop = 1: Enable drive.
Any error will be deleted.
= 0: STOP active: The axis stops with the fast stop ramp
(QuickĂStop) or with the normal stop ramp
(compareĂPNUĂ1020/605Dh).
The positioning task counts as finished.
B2
BRAKE Brake If the SFC−LACI is not in the ready" state
(Status word does not equal operation_enable"):
= 0: Close brake / clamping unit
= 1: Open brake / clamping unit.
In the ready" condition, the controller takes over control of the
brake output. Control of the output via the PLC is then not possible.
B3
RESET Reset Fault With a rising edge a fault is acknowledged and the fault number is
deleted
B4 ć reserved, must be at 0
B5
LOCK Lock HMI access Controls access to the parameterisation interface:
= 1: MMI and FCT may only observe the drive, the device control
(HMI control) cannot be taken over by MMI and FCT.
= 0: MMI or FCT may take over the device control (in order to modify
parameters or to control inputs)
B6
OPM1 Select Operating
Mode
= 00: Record selection
= 01: Direct mode
10 reserved
B7
OPM2
= 10: reserved
= 11: reserved