Festo Контроллеры двигателя SFC-LAC - Manual (Page 64)

3. Installation
3−14
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
3.5 Parameterising interface
Serial interface for parameterising, commissioning and
diagnosing.
Note
For connecting a PC to the SFC−LACI, use only the cable
specified in Tab. 3/2.
· If necessary, remove the protective cap from the
parameterising interface.
· Connect the following terminals with the programming
cable:
ć the socket on the SFC−LACI
ć a serial interface COMx of the PC.
M8 socket Description
1 2 4 3 1 GND Ground
2 RXD RS232: 1)
Receiving cable of PC,
transmitting cable of SFC−LACI
3 TXD RS232: 1)
Transmitting cable of PC,
receiving cable of SFC−LACI
4 ć (reserved, do not use)
1) The levels correspond to the RS232 standard.
Tab. 3/7: Parameterising interface (RS232) of the SFC−LACI