Festo Контроллеры двигателя SFC-LAC - Manual (Page 149)

5. Commissioning
5−53
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
Description to 3. Fault handling
Description of errors and warnings see section 6.3.
3.1 An error is shown with SCON.B3 FAULT.
} Positioning can no longer be undertaken.
3.2 A warning is shown with SCON.B2 WARN.
} Positioning can still be undertaken.
3.3 Acknowledge fault with positive edge at
CCON.B3ĂRESET.
} Fault bit SCON.B3 FAULT or
SCON.B2 (WARN) will be reset.
} SPOS.B2 MC will be set.
} Drive is ready to operate.
ć or ć
3.4 Acknowledge fault with negative edge at
CCON.B0ĂENABLE.
} Fault bit SCON.B3 FAULT or
SCON.B2 WARN will be reset.
} SPOS.B2 MC will be set.
} Establish readiness to operate again
(see examples 1, Tab. 5/7 and 2, Tab. 5/8)
Caution
After the removal of ENABLE, the drive is no longer under
position control. This may cause injury to people and maĆ
terial damage.
Ĉ With vertical or sloping drive mountings, the moving
mass might slide down; see section 1.1.3.