Festo Контроллеры двигателя SFC-LAC - Manual (Page 82)

4. Control panel (only type SFC−LACI−...−H2)
4−6
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
4.2 The menu system
Status display and main menu
When the logic voltage is switched on, the SFC−LACI carries
out an internal check. The display briefly shows the Festo
logo then changes to the status display.
The status display shows the following information:
ć The type designation of the SFC−LACI
ć The type of connected drive
ć The position of the drive x
a
= .... (still without significance
when unit is switched on)
ć The PROFIBUS address
ć The current setting of the device control
(HMI = Human Machine Interface)
The main menu is accessed from the status display using the
<Menu> key. The currently active key function is displayed in
the lower lines of the LCD display.
SFC–LACI...
D...
Xa = 0.00 mm
HMI:off PB:none
<Menu>
} Diagnostic
Positioning
Settings
V
ESC <Menu>
<––> OK <Enter>
} HMI control
LCD adjustment
v ESC <Menu>
<––> OK <Enter>