Festo Контроллеры двигателя SFC-LAC - Manual (Page 49)

2. Fitting
2−5
Festo P.BE−GDCP−SFC−LACI−PB−E N en 0812NH
2.3 Mounting the controller
You can mount the SFC−LACI in one of two ways:
1. Wall mounting on a flat surface
2. H−rail mounting
Note
Mount the SFC−LACI or hat rail so that there is sufficient
space for
heat dissipation (above and below at least
40Ămm).
2.3.1 Wall mounting
You will need:
ć A mounting surface of approximately 250 x 320 mm
ć 2 sets of central supports type MUP−8/12 (accessory
items), (the four brackets are clipped into the edge of the
housing, see Fig. 2/2).
ć 4 tapped holes for screw size M3 with matching screws.
120 mm
Fig. 2/2: Wall mounting