Black Box COMPACT T1 MT850A - Manual (Page 160)

5-76 Compact T1 - Release 6.1
CLI Commands
set
set (ds1)
Use the set (ds1) command to set up DS1 interfaces. The command specifies a range of
interfaces and the setting to apply.
Syntax: set {ds1-addr} {setting}
Example: set a:1 framing esf
To set DS1 1 (port 1) on the controller (slot A) to use ESF framing.
{ds1-addr}
DS1 address in the form {slot:port}.
{setting}
slot A for the controller card, or 1-6 for service cards.
port Port number range or all.
down Set the DS1 as Out-of-Service
up Set the DS1 as In-Service. Enables alarm reporting (and LED) for the
port specified
bpviolation Set the bipolar violation alarm threshold. Command only functional
when in TR-08 mode
none Remove bipolar violation alarm
tenneg4 Set bipolar violation alarm threshold to .0001
tenneg5 Set bipolar violation alarm threshold to .00001
tenneg6 Set bipolar violation alarm threshold to .000001
equipment Set equipment loopback on the DS1
Note: this feature is only available through Quad T1 cards. It is not
available on the controllers.
loopdown Disable equipment loopback on the DS1
loopup Enable equipment loopback on the DS1
fdl Set the Facilities Data Link (FDL) capabilities
none Disable FDL output messages
alm13 Enable TR-08 alarm 13 FDL messages
alm16 Enable TR-08 alarm 16 FDL messages
t1403 Enable T1.403 FDL performance messages