Black Box COMPACT T1 MT850A - Manual (Page 238)

5-154 Compact T1 - Release 6.1
CLI Commands
set
set (router-lan) collision threshold
Use the set (router-lan) collision threshold command to specify the thresholds used to
determine excessive collision alarm state.
Syntax: set {rtr_lan-addr} collision threshold {high|low}
{count}
Example: set 3 "Adit50" collision threshold high 500
The example will set the high alarm threshold to 500, for the local LAN interface
on slot 3.
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
{high|low}
{count}
The number of collisions in the collision interval time period. Range is 0 - 65536.
slot Slot number (1-6) that contains the Router card.
port Port number of the Router is 1.
"profile-name" The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
high The number of collisions in the collision interval time period above
which an excess collision alarm is raised.
low The number of collisions in the collision interval time period below
which a standing excess collision alarm is cleared.