Black Box COMPACT T1 MT850A - Manual (Page 301)

Compact T1 - Release 6.1 5-217
CLI Commands
show
show (ocudp)
Use the show (ocudp) to display baud, loopdetect, error correction, switched and enhanced
switched service and secondary channel provisioning.
Syntax: show {ocudp-addr}
Example: show 2:1
SLOT 2:
Settings for OCUDP Port 1:
Up/Down: UP
Baudrate: 56000
Loopdetect Types Enabled:
CSU Non-Latching
DSU Non-Latching
OCU Non-Latching
Error Correction: DISABLE
Secondary Channel: DISABLE
{ocudp-addr}
The {slot:port} address of the OCU-DP card to display.
show radius
The show radius command displays the RADIUS configuration settings for the Controller.
Syntax: show radius
Example: show radius
RADIUS Configuration Parameters:
Authentication: enabled for
Slot 4
Slot 5
NAS Identifier:
Retry count: 3
Timeout (sec): 3
Server(1) : UNUSED
Server(2) : UNUSED
Server(3) : UNUSED
slot Slot number (1-6) of the chassis where the OCU-DP is located. If no port
is specified, all ports will be displayed.
port Port number or range.