Black Box COMPACT T1 MT850A - Manual (Page 187)

Compact T1 - Release 6.1 5-103
CLI Commands
set
set (router) enhanced security
Use the set (router) enhanced security command to enable or disable enhanced login security
on the Router. When enabled the user will not receive any login prompt or other output until the
security password is typed. The security password is set via the set (router) password command.
Syntax: set {rtr_card-addr} enhanced security
{disable|enable}
Example: set 5 enhanced security enable
The example will enable the enhanced security on the Router card in slot 5.
Note: A set 5 password security "password" command must be completed
before the enhanced security can be enabled.
See, set (router) password on page 5-129
{rtr_card-addr}
The slot number (1-6) that contains the Router (IP or CMG) card.
{disable|enable}
set (router) hookflash
Use the set (router) hookflash command to specify the flash maximum time in milliseconds.
This is the time beyond which a disconnect, rather than a hookflash event, is declared. Flash
event processing may be turned off by setting this parameter to zero. This command applies to
the CMG Router card only.
Syntax: set {cmg_card-addr} hookflash {milliseconds}
Example: set 5 hookflash 500
The example will set the hookflash to 500 milliseconds (half a second) on the
CMG card in slot 5.
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{milliseconds}
Maximum flash length, between 500 and 1500 milliseconds, or 0. Default is 1500
milliseconds.
disable Disable enhanced login security
enable Enable enhanced login security