Set (router-lan) collision, Set (router-lan) collision -153 – Black Box COMPACT T1 MT850A User Manual
Page 237
Compact T1 - Release 6.1
5-153
CLI Commands
set
set (router-lan) collision
Use the set (router-lan) collision commands to configure collision alarms.
set (router-lan) collision interval
Use the set (router-lan) collision interval command to specify the time interval over
which excessive collision alarms are calculated.
Syntax:
set {rtr_lan-addr} collision interval {seconds}
Example:
set 3:1 collision interval 0
The example will set the local LAN interface on slot 3 to disable collision
alarms.
{rtr_lan-addr}
The Router (IP or CMG) address is in the form {slot:port} or {slot "profile-name"}.
{seconds}
Range from 0 to 65535. With a value of 0 collision alarms will be disabled.
slot
Slot number (1-6) that contains the Router card.
port
Port number of the Router is 1.
"profile-name" The profile name for the Router interface. Name must be enclosed in
quotes, with a maximum length of 11 characters.