Black Box COMPACT T1 MT850A - Manual (Page 504)

15-6 Compact T1 - Release 6.1
V.35/V.54 Cards
Card Configuration
Card Configuration
The V.35 Service cards can be configured, using the Command Line Interface (CLI).
CLI Commands
The following commands are used to configure the V.35 Service cards. For detailed
information on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels.
l disconnect
Removes a connection created by the connect command.
l set (v35)
Setup of channels of a V.35 card (clock, clear to send, data, equipment, line,
receive clock invert, speed, transmit clock invert).
l set (v54)
Set the V.54 loopback test parameters.
l show (v35)
Displays the current settings for V.35 (clear to send, timing, Rx clock
inversion, Tx clock inversion, data inversion, data speed, data rate,
loopback)
l show (v54)
Displays the current settings for V.54 (CTS, timing, Rx clock inversion, Tx
clock inversion, data inversion, data speed, data rate, Rx LB, Rx Addr, test
address, Tx Prep count, Rx Prep count, test pattern, ignore ACK, loopback)
l status (v35)
Displays the current status of the specified V.35 (data terminal ready,
request to send, data carrier detect, clear to send, data set ready).
l status (v54)
Displays the current near-end line status of the specified V.54 (DCD, CTS,
DSR, RTS, DTR, BERT).