Black Box COMPACT T1 MT850A - Manual (Page 482)

14-8 Compact T1 - Release 6.1
Router (CMG) Card
Card Configuration
Card Configuration
The CMG Service card has the option of configuration through CLI or the Router
menu-driven user interface, which is accessed through Telnet. The following CLI
commands are all router related. For information on the Router menu-driven user
interface, see the CMG Router User Manual.
NOTE: The default IP address for the Adit CMG Router is 10.0.0.0.
CLI Commands
Many of the router features can be configured directly with CLI commands.For
detailed information on the following Router commands, see Chapter 5, CLI
Commands.
Minimum Configuration Required
The CMG Service card requires an external call agent to operate as an MGCP-
controlled media gateway or IAD.
The gateway must contact the call agent, on power up or reset. Therefore, the
following configuration commands MUST be used to enter the call agent’s IP
address or domain name.
set {rtr_card-addr} mgcp callagent address {ip-addr}
set {rtr_card-addr} mgcp up
All other CLI commands listed below MAY be used to set customer media gateway
options, but may not be necessary, since the defaults have been chosen to meet the
most common expected uses. Some configuration may be necessary for proper
interoperation with a given call agent.
l add (router) dns proxy
Enable DNS proxy and add a remote DNS server address to the router card
l add (router) remote
Add a remote WAN profile to the WAN profile table
l add (router) snmp community
Add a SNMP community to an interface on the router card
l add (router) snmp trap
To specify a destination to send SNMP trap messages