Black Box COMPACT T1 MT850A - Manual (Page 251)

Compact T1 - Release 6.1 5-167
CLI Commands
set
set (router-trunk) up/down
Use the set (router-trunk) up/down command to set the WAN trunk up or down. When the
Router trunk is set down a link failure will not cause an alarm. This can be used to eliminate
alarms from Router trunks that are not in-use. When the Router trunk is set up, a link failure on
the WAN trunk will cause an alarm to be reported to the Adit.
Syntax: set {rtr-trunk-addr} {down|up}
Example: set 2:1:1 down
The example will set the first Router trunk interface on slot 2 down.
{rtr-trunk-addr}
In the form {slot:port:trunk}.
{up|down}
slot Slot number (1-6) of the Adit that contains the Router (IP or CMG) card.
port Port number of the Router is 1.
trunk Trunk number for this port, 1-24.
down Set the WAN down.
up Set the WAN up.