Black Box COMPACT T1 MT850A - Manual (Page 228)

5-144 Compact T1 - Release 6.1
CLI Commands
set
set (router) voip
Use the set (router) voip commands to set Voice over IP (VoIP) parameters. This command
applies to the CMG Router card only.
set (router) voip default
Use the set (router) voip default command to set all VoIP options to their default values.
Syntax: set {cmg_card-addr} voip default
Example: set 3 voip default
The example will set the VoIP options to their default settings, on the CMG card
in slot 3.
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
set (router) voip dtmf edge
Use the set (router) voip dtmf edge command to configure the CMG to notify DTMF
digits on the leading or trailing edge. Setting this configuration item to leading edge shall
cause the CMG to act on DTMF digits, for collection or notification purposes, at the time
the key is pressed. Setting this configuration item to trailing edge shall cause the CMG to
act on DTMF digits at the time the key is released. This command takes effect immediately.
Syntax: set {cmg_card-addr} voip dtmf edge {leading|trailing}
Example: set 3 voip dtmf edge trailing
The example will set the CMG in slot 3 to notify the call agent of digits when
the key is released.
{cmg_card-addr}
The slot number (1-6) that contains the CMG card.
{leading|trailing}
leading Will cause the CMG to act on DTMF digits, for collection or notification
purposes, at the time the key is pressed.
trailing Will cause the CMG to act on DTMF digits at the time the key is
released.