Black Box COMPACT T1 MT850A - Manual (Page 260)

5-176 Compact T1 - Release 6.1
CLI Commands
set
set (router-voice) endpoint suffix
Use the set (router-voice) endpoint suffix command to set the variable part of the MGCP
endpoint name for one or more voice channels. The default suffix is the voice channel number.
Note: the endpoint prefix is combined with the endpoint suffix to form a complete MGCP
endpoint name for each voice channel. If the defaults are used, the endpoint names are "aaln/1",
aaln/2", "aaln/3", etc. These names are used by a call agent to address the channel. This
command applies to the CMG Router card only.
Syntax: set {cmg_voice-addr} endpoint suffix {"suffix"}
Example: set 2:1:1:3 endpoint suffix "bob"
The example will set endpoint name suffix to "bob" for voice channel 3 on the
CMG card in slot 2.
{cmg_voice-addr}
In the form {slot:voip:port}
{"suffix"}
An identifier with a maximum of 16 characters, enclosed in quotes.
slot The slot number (1-6) that contains the CMG card.
voip To designate VoIP 1:1 is used.
channel Channel number for the router is 1-48, range or all