Black Box COMPACT T1 MT850A - Manual (Page 69)

Compact T1 - Release 6.1 4-7
Configuration
Basic System Setup
Set Up the Router Card
The following is the basic setup, see the Adit Router User Manual or Quick Start
Guide for the following configuration setups:
l PPP Internet Connection and Public IP Address Routing
l Frame Relay Internet Connection and Public IP Address Routing
l
Internet Connection using PPP, NAT/PAT and Firewall Filters
l Internet Connection using NAT and Static NAT Addresses
l
PPP Internet Connection and Public IP Address Routing
l Back-to-Back with PPP
Command Description
set {ds0-addr} type data Confirm DS0 is set to type data.
ds0-addr = {slot:port:channel} of DS0
Example: set a:1:1-24 type data
connect {slot:port:trunk}
{slot:port:channel}
Cross-connect T1 to router card.
Example: connect a:1:1-24 6:1:1 (router in slot 6)
set {router-addr} proxy Disable/enable router proxy.
router-addr = {slot:port}| of router card.
Example: set 6:1 proxy disable.
set {slot:port} up Set Router LAN as In-Service.
Example: set 6:1 up
telnet {router_card-addr} Telnet to Router card.
router_card-addr = {slot} location of router card
Example: telnet 6 (if earlier than 3.0 release {slot:port}
must be used)
Local and Remote Profile Setup
reinitialize To enable any configuration changes, the card must be
reinitialized.