Lenze EVS9332xS - Manual (Page 190)

Commissioning
Setting the speed feedback
Resolver at X7
6
6.6
6.6.1
l
6.6−1 EDSVS9332S EN 6.0−07/2013
6.6 Setting the speed feedback
The feedback signal can either be supplied via input X7 or via input X8.
ƒ At X7 a resolver can be connected.
ƒ At X8 an encoder can be connected.
– Incremental encoder TTL
– SinCos encoder
– SinCos encoder with serial communication (single−turn or multi−turn)
The resolver or encoder signal for slave drives can be output at the digital
frequency output X10.
)
Note!
ƒ Use a SinCos encoder with serial communication (multi−turn)
if homing of the drive is not possible. Please specify the
motor/encoder combination in your order.
ƒ You can only use 2 of the 3 interfaces X8, X9, X10
simultaneously. Due to this it may be possible that the
incremental encoder input cannot be activated or the digital
frequency input / digital frequency output does not work.
– This dependency does not apply if the digital frequency
output X10 is set to reproduction of the input signals at X8
or X9 (C0540 = 4 or 5).
– To deactivate the digital frequency input, it may be
necessary to delete the internal signal link from function
block DFIN to the following function block. Remove the
function block DFIN from the processing table.
6.6.1 Resolver at X7
Resolvers can be operated at X7. For the wiring diagram and the pin
assignment of X7, please refer to chapter "Wiring of the standard device"
® "Wiring of the feedback system".
ƒ C0025 = 10 (Lenze setting)
ƒ Monitoring (SD2) of the resolver and the resolver cable for open circuit:
C0586 = 0 (TRIP, Lenze setting)
C0586 = 2 (warning)
C0586 = 3 (off)
6.6.2 Incremental encoder with TTL level at X8
Incremental encoders with TTL level can be operated at X8. For the wiring
diagram and the pin assignment of X8, please refer to chapter "Wiring of the
standard device"
® "Wiring of the feedback system".
Description
Activation