Lenze EVS9332xS - Manual (Page 243)

Configuration
Code table
8
8.4
l
8.4−2 EDSVS9332S EN 6.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0005
s
SIGNAL CFG 1000 Signal configuration
(predefined basic configurations)
0 COMMON Modified basic configuration
1
2
11 86xx −1−
86xx −2−
86xx −11− Compatible to 86xx frequency inverter
20
21 922x −20−
922x −21− Compatible to 922xx frequency inverter
C0005
s
SIGNAL CFG 1000 100 empty All internal links are deleted
1000 Speed control The first digit indicates the predefined basic
function, e. g.:
l 1xxx: Speed control
l 4xxx: Torque control with speed limitation
The second digit indicates additional
functions
x0xx: No additional function
x1xx: Brake control
x9xx: In the case of quick stop, the complete
drive system is brought to zero speed in a
phase−controlled manner
The third digit indicates the predefined
voltage source for the control terminals:
l xx0x: External supply voltage
l xx1x: Internal supply voltage
The fourth digit indicates the predefined
device control:
l xxx0: Terminal control
l xxx1: RS232, RS485 or optical fibre
l xxx3: INTERBUS or PROFIBUS−DP
l xxx5: System bus (CAN)
4000 Torque control with speed limitation
5000 Master for digital frequency coupling
6000 Slave to digital frequency bus
7000 Slave to digital frequency cascade
C0006
s
OP MODE à
Motor control operation
1 SSC norm Y sensorless star standard
motor à Depending on C0086
l Change of C0086 resets value to the
assigned default setting
l Change of C0006 sets C0086 = 0!
2 Servo async. Y asynchronous motor,
star
3 Servo PM−SM Y PM synchronous motor,
star
11 SSC standard motor sensorless
standard motor, delta
22 Servo asyn asychronous motor, delta
C0009 LECOM
ADDRESS
1 1 {1} 99 LECOM device address
Bus device number when operated via
interface
l 10, 20, ..., 90 reserved for broadcast to
device groups for RS232, RS485, fibre
optics.
C0011 NMAX 3000 500 {1 rpm} 16000 Max speed N
max
Reference value for the absolute and relative
setpoint selection for the acceleration and
deceleration times.
l Parameter setting via interface:
– Greater changes in one step should only
be made when the controller is
inhibited.