Lenze EVS9332xS - Manual (Page 285)

Configuration
Code table
8
8.4
l
8.4−44 EDSVS9332S EN 6.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C1094 DENOMINATO
R
0.000
1
0.0001 {0.0001} 100000.0000 FEVAN1
Denominator
C1095 OFFSET 0 0 {1} 1000000000 FEVAN1
Offset setting
C1096
s
IN 1000 FIXED0% ® Selection list 1 FEVAN1
Configuration of analog input signal
C1097
s
FEVAN1−LOAD 1000 FIXED0 ® Selection list 2 FEVAN1
Configuraton of digital input signal
C1098 (C1096) g −32768 {1} 32767 FEVAN1
Display of analog input signal
C1099 (C1097) g FEVAN1
Display of digital input signal
C1100 FUNCTION 1 FCNT1
Function selection
1 Return If |counter content| ³ |FCNT1−CMP−Val|,
FCNT1−EQUAL is set to HIGH for 1 ms
2 Hold if >= If |counter content| ³ |FCNT1−CMP−Val|, the
counter stops
3 Hold if = If |counter content| = |FCNT1−CMP−Val|, the
counter stops
C1101
s
® Selection list 1 FCNT1
Configuration − analog input signals
1 LD−VAL 1000 FIXED0%
2 CMP−VAL 1000 FIXED0%
C1102
s
® Selection list 2 FCNT1
Configuration of digital input signals
1 CLKUP 1000 FIXED0
2 CLKDWN 1000 FIXED0
3 LOAD 1000 FIXED0
C1103 g −32768 {1} 32768 FCNT1
Display of analog input signals
1 (C1101/1)
2 (C1101/2)
C1104 g FCNT1
Display of digital input signals
1 (C1102/1)
2 (C1102/2)
3 (C1102/3)
C1120 SYNC MODE 2 0
1
2 Sync switched off
CAN sync activated
Terminal sync activated SYNC1
Function
C1121
s
2 0 {1 ms} 13 SYNC1
The interpolation is restarted with every sync
signal.
1 SYNC CYCLE 2 SYNC1
Definition of the cycle time of the sync
signals (in the slave); only for system bus
2 INTERPOL. CYCL 2 SYNC1
Definition of the interpolation time between
the sync signals (in the slave), only for
terminal
C1122 SYNC TIME 0.460 0.000 {0.001
ms}
10.000 SYNC1
Phase shift between CAN sync and internal
control program cycle
l For system bus only
l Depends on baud rate and bus load