Lenze EVS9332xS - Manual (Page 261)

Configuration
Code table
8
8.4
l
8.4−20 EDSVS9332S EN 6.0−07/2013
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0471 FCODE 32 BIT 0 0 {1} 4294967296 FCODE 32 bits digital
Freely configurable code for digital signals
l Data words C0470 and C0471 are in
parallel and identical
C0472 FCODE
ANALOG
−199.99 {0.01 %} 199.99 Freely configurable code for relative analog
signals
1 0.00
2 0.00
3 100.0
0
6 100.0
0
... ...
19 0.00
20 0.00
C0473 FCODE ABS −32767 {1} 32767 FCODE
Freely configurable code for absolute analog
signals
1 1
2 1
3 0
... ...
9 0
10 0
C0474 FCODE PH −2147483648 {1} 2147483647 FCODE
Freely configurable code for angle singals
1 rev. = 65536 inc
1 0
... ...
5 0
C0475 FCODE DF −16000 {1 rpm} 16000 FCODE
Freely configurable code for angular
difference singals
1 rev. = 65536 inc
1 0
2 0
C0490
s
FEEDBACK POS 0 Position feedback system
Feedback system for the position controller
0 Resolver at X7 The feedback system can be combined with
the settings C0495 = 0, 1, 2, 3, 4.
1 Encoder TTL at X8 The selection also sets C0495 to the same
value.
2 Sin/cos encoder at X8
3 Hiperface absolute value encoder
singleturn at X8
4 Hiperface absolute value encoder
multiturn at X8
C0495
s
FEEDBACK N 0 Speed feedback system
Feedback system for the speed controller
0 Resolver at X7 The feedback system can be combined with
the settings C0490 = 0, 1, 2, 3, 4.
l The rotor displacement angle in C0058 is
set to −90°.
1 Encoder TTL at X8 The selection also sets C0490 to the same
value.
2 Encoder sin at X8
3 Absolute ST at X8
4 Absolute MT at X8