Rockwell Automation 22B PowerFlex 40 FRN 1.xx - 6.xx User Manual
Page 104
A-4
Supplemental Drive Information
PowerFlex 40 Adjustable Frequency AC Drive FRN 1.xx - 6.xx User Manual
Publication 22B-UM001H-EN-E
Category
Specification
Environment
Altitude:
1000 m (3300 ft) max. without derating
Maximum Surrounding Air
Temperature without derating:
IP20, NEMA/UL Type Open:
IP30, NEMA/UL Type 1:
Flange Mount:
IP66, NEMA/UL Type 4X:
–10 to 50° C (14 to 122° F)
–10 to 40° C (14 to 104° F)
Heatsink: –10 to 40° C (14 to 104° F)
Drive:
–10 to 50° C (14 to 122° F)
–10 to 40° C (14 to 104° F)
Cooling Method
Convection:
Fan:
0.4 kW (0.5 HP) drives
All other drive ratings and 0.4 kW (0.5 HP)
1-Phase drives with Integral “S Type” EMC Filter
Storage Temperature:
–40 to 85 degrees C (–40 to 185 degrees F)
Atmosphere:
Important: Drive must not be installed in an
area where the ambient atmosphere contains
volatile or corrosive gas, vapors or dust. If the
drive is not going to be installed for a period of
time, it must be stored in an area where it will not
be exposed to a corrosive atmosphere.
Relative Humidity:
0 to 95% non-condensing
Shock (operating):
15G peak for 11ms duration (±1.0ms)
Vibration (operating):
1G peak, 5 to 2000 Hz
Control
Carrier Frequency
2-16 kHz. Drive rating based on 4 kHz.
Frequency Accuracy
Digital Input:
Analog Input:
Analog Output:
Within ±0.05% of set output frequency.
Within 0.5% of maximum output frequency,
10-Bit resolution
±2% of full scale, 10-Bit resolution
Speed Regulation - Open Loop
with Slip Compensation:
±1% of base speed across a 60:1 speed range.
Stop Modes:
Multiple programmable stop modes including -
Ramp, Coast, DC-Brake, Ramp-to-Hold and
S Curve.
Accel/Decel:
Two independently programmable accel and
decel times. Each time may be programmed from
0 - 600 seconds in 0.1 second increments.
Intermittent Overload:
150% Overload capability for up to 1 minute
200% Overload capability for up to 3 seconds
Electronic Motor Overload
Protection:
Provides class 10 motor overload protection
according to NEC article 430 and motor
over-temperature protection according to NEC
article 430.126 (A) (2). UL 508C File 29572.
Electrical
Voltage Tolerance:
100-120V ±10%
200-240V ±10%
380-480V ±10%
460-600V ±10%
Frequency Tolerance:
48-63 Hz
Input Phases:
Three-phase input provides full rating. Single-phase
operation provides 35% rated current.
Displacement Power Factor:
0.98 across entire speed range
Maximum Short Circuit Rating:
100,000 Amps Symmetrical
Actual Short Circuit Rating:
Determined by AIC Rating of installed fuse/circuit
breaker
Transistor Type:
Insulated Gate Bipolar Transistor (IGBT)
22B-UM001.book Page 4 Wednesday, January 22, 2014 11:04 AM