Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 275)

Block Transfer
Chapter 18
18-10
Keystrokes
Enter a block transfer read (like this example) by performing the
following steps.
Block Transfer 0 appears in the lower left corner of the screen, above the
processor’s current programming mode. BLOCK
XFER
1
EN
BLOCK X FER READ
DATA ADDR:
MODULE ADDR:
BLOCK LENGTH:
FILE:
030
100
01
110- 110
DN
110
07
010
07
Note that the words BLOCK TRANSFER READ are flashing.
Insert the following values. The cursor moves automatically through the
block transfer read instruction. The values are:
DATA ADDRESS 030
MODULE ADDRESS 130
BLOCK LENGTH 05
FILE 070Ć074
where the Data Address is the first possible timer/counter address; the
Module Address is the rack, group, and slot number; the Block Length is
the number of words to be transferred; and File is the address of the
starting word to be transferred.
The instruction should look like this:
EN
BLOCK X FER READ
DATA ADDR:
MODULE ADDR:
BLOCK LENGTH:
FILE:
030
130
05
070- 074
DN
113
07
013
07
The Block Transfer enable bit is 01307; the done bit is 11307.